Basic knowledge of using pneumatic tools

In the use of pneumatic tools, there are a lot of people do not pay attention to, how to correctly use the relevant knowledge of pneumatic tools, resulting in the use of the problem, especially the reliability of life. This is what we do not want to see. Therefore, it is necessary for us to popularize the basic common sense of using pneumatic tools.
1. The reaction force torque during the use of pneumatic tools. Some pneumatic tools are likely to produce reaction force torque during normal use, which makes the operator's body in a tense state, affects the balance of the body, and may clip fingers. Be especially careful when using multi-axis nut lock attachment equipment, screwdrivers, ratchet wrenches, bevel wrenches, rotors, tapping machines, pipe beveling machines, etc. The operator should be careful to take precautions against undesirable reaction torque.
2. When using pneumatic tools, air compressors should be selected according to actual needs. The correct selection of air pressure is relatively simple. Generally, there are 8 atmospheres and high pressures such as 12 atmospheres (175Psi). If there are no special requirements, 8 atmospheres are generally sufficient. The air flow rate of air compressors is determined by power. This is generally sufficient for supplying a single tool. Before using pneumatic tools in a reliable and standardized manner, please be sure to read this manual. Only after fully understanding the contents can pneumatic tools be used in the workplace, and its contents must be strictly implemented.
In short, in the process of use, you must follow the operating steps described in the instructions for use. Do not use pneumatic tools with high loads and do not exceed the operating pressure. At the same time, often make pneumatic tools work in an environment that exceeds the operating pressure, which will greatly reduce The service life of the tool itself. Always remove the pneumatic tool from the air source when replacing tools or accessories. Wear goggles when possible. Earplugs. Masks to defend themselves. Do not wear loose clothing when operating. A scarf. Tie or bracelet to avoid danger caused by moving or rotating parts. When the pneumatic tool is connected to the high-pressure air source, do not press the trigger when it is not in use. Ensure the condition of spare parts at all times, loose spare parts can cause serious danger. When replacing worn parts, use special parts. Do not use the air pressure pipe for damage or impact. Do not point tools at yourself or others. Before use, check whether the air pressure pipe is fragile or damaged. If the above conditions are found, please update immediately to maintain and lock all nuts and screws, and make sure that all equipment is in a reliable state.

More news